Holybro PM07 Power Module (14S)

Description

Description:

This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.

PM07 has two 5.2V power output port that can provide redundant powerto the flight controller, with independent circuits, BEC ICand circuitry.

It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector.

Specifications

• Input voltage: 2S-14S
• PCB Cont.Current Rating: 90A
• PCB BurstCurrent Rating: 140A (
• Output: DC 5.2V& 3A Max
• Voltage Divider: 18.182
• Amperes per Volt: 36.364

Please Note:

1. The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60Aburst current (
2. This PM02 Power Module uses analog data outputand is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).

Mechanical Specification:

• Dimensions:68*50*10 mm
• Mounting Holes:45*45mm
• Weight: 43.8g

Setup guide for PX4 & Ardupilot can be found in theHolybro Dochere.
PM07 User guide can befound here

Package Include:

• 1xPM07 board
• 1x80mm XT60 connector wire (installed)
• 1x Electrolytic capacito: 220uF 63V (installed)
• 2xJST GH 10P Cable
• 1xJST GH 8P Cable
• 2xJST GH 6P Cable